![]() ![]() From the POSITIVE (RED) and the NEGATIVE (BLACK) terminals, remove the nut, split lock and flat washer.Locate the Positive and Negative terminals on the inverter.Vehicle: Connect to the chassis, unpainted frame part, or engine block of the vehicle.įixed location: Connect to a ground rod or other appropriately rated ground.ĬONNECTING INVERTER CABLES TO THE INVERTER Attach the other end of the wire to a properly grounded location:.Then, replace the other nut and tighten it securely. Attach the grounding wire’s ring connector to the ground terminal of the inverter.Remove the outer nut and loosen the first locking washer.Locate the chassis ground screw on the back of the inverter.NOTE: Do not turn on the inverter or the power source until the inverter and the power source are grounded. The inverter should be grounded, using a 15 AWG copper wire (included). To avoid electrical shock, it is necessary to ground the inverter as well as the device powering it. IMPORTANT: Make sure to connect your inverter only to a 12-volt power supply. The inverter and power source must be in the OFF mode. Negative Battery Cable Terminal (Black) CONNECTING INVERTER CABLES.The fans do not run when the inverter is turned off. To keep the inverter cool, the fan turn on depend on the temperature in the inverter. Green indicates Power ON Red indicates Overload/Interruption in power Do not use the inverter with a product that draws a higher wattage than the inverter can provide, as this may cause damage to the inverter and product.Connecting to a 6V or 16V battery will cause damage to the inverter. Do not attempt to connect the inverter to any other power source, including an AC power source. Only connect the power inverter to a 12V battery or power supply.The ideal air temperature for operation is between 50° and 80☏. Do not place the inverter in direct sunlight.Do not place the inverter on or near heating vents, radiators or other sources of heat or flammable meterials.For the most effective use, place the power inverter on a flat surface. ![]() Turning off controls will not reduce this risk. To reduce risk of electric shock, unplug unit from outlet before attempting any maintenance or cleaning.Incorrect reassembly may result in a risk of electric shock or fire. Do not disassemble the unit take it to a qualified serviceman when service or repair is required.Use of an attachment not recommended or sold by the unit manufacturer may result in a risk of fire, electric shock, or injury to persons.Do not expose inverter to rain or snow.Please read, understand and follow these instructions and precautions carefully. This manual will show you how to use your inverter safely and effectively. This manual contains important safety and operating instructions for power inverter 1000W. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |